So I shot some Wet white powder last night and after curing I find one red line in the item. Now I have not used any red powder in months and I do not even have any red powder in the shop.... So how the heck did I end up with a red line in the work?? A second coat covered it up.
Announcement
Collapse
No announcement yet.
riddle me this batman
Collapse
X
-
Re: riddle me this batman
Originally posted by CrimsonI used my EW pro gun for this job not my King gun. The gun was clean really well with air before I put the white in and the cup was also cleaned.
Just weird I have no idea where the red came from.I really like that
Comment
-
Re: riddle me this batman
Originally posted by THEKINGOriginally posted by CrimsonI used my EW pro gun for this job not my King gun. The gun was clean really well with air before I put the white in and the cup was also cleaned.
Just weird I have no idea where the red came from.I really like that
Comment
-
Re: riddle me this batman
Originally posted by dustyspowdercoatingIf there was any red paint on the part before, some might have been missed. Red, I think is the worst for bleeding thru. And it doesn't take much. I missed a few specks and they turned into big splots.Comment
-
Re: riddle me this batman
I know sometimes if we miss marker, or dye, or even if we don't, and it's penetrated the metal deeply, it will come thru lighter color during the cure cycle.
I'm no scientist, but it seems like the heat pukes the ink out of the pores.Comment
Comment